info@truex-consultancy.com
All courses
SAEOpen for enrolment

Supplier Auditing Essentials

A GMP certificate shows what an authority accepted. An audit shows you what the site actually does.

How to audit a contract manufacturer, a contract laboratory or another supplier under EU GMP Chapter 7, from the decision to audit to the decision on the supplier. You plan a routine or for-cause audit, prepare from the documents, work on site, write and classify findings, issue the report, and verify the response until every finding is closed on evidence. One audit of a contract manufacturer runs through the five lessons, and a workshop applies the method to a for-cause audit of a contract laboratory. Where EU GMP sets no figure, such as audit frequency, deadlines and finding levels, the course labels the figure as good practice or industry practice.

Duration
About 3 hours, self-paced
Level
Practitioner
Lessons
5 lessons

What the course teaches and assesses

  • Tell a routine audit from a for-cause audit, set the interval by risk, and run the timeline from notification to close-out, including a review of everything since the last audit
  • Issue the document request, complete the desk review, build the audit plan and agenda, and run the three-way check of procedure against quality agreement, EU GMP and practice
  • Run the opening meeting, examine each area for the key checks, and trace records back to the source with objective evidence and interviews
  • Write a finding as fact, requirement and evidence, classify it on a written scale, and issue the report within the agreed time
  • Assess the supplier's response and CAPA plan, verify each action on evidence, and record the decision on the supplier's status

Lessons

  1. 1The audit from start to finish: why you audit and who audits, routine and for-cause audits, and the timeline from notification to close-out
  2. 2Preparing the audit: what to request and read, the audit plan and agenda, and the three-way check
  3. 3On site: the opening meeting and conduct, what to look for area by area, and tracing, evidence and interviews
  4. 4Findings and the report: writing a finding, classifying findings, and the closing meeting and the report
  5. 5After the audit: assessing the response, verifying CAPA and close-out, and the decision and records
  6. Scored final exam and dated certificate

What this course does and does not do

Covered

  • Supplier and contract acceptor audits as EudraLex Volume 4, Chapter 7 expects them: planning, preparing, conducting, reporting and follow-up
  • Narrated topics, a pause-and-answer question in every topic, a knowledge check after each lesson, a workshop on a for-cause audit, a final assessment of 20 questions and a certificate of completion
  • Four printable job aids

Not covered

  • Drafting your supplier audit procedure or your quality agreements
  • Auditing your own site, which Self-Inspection Essentials covers
  • An introduction to GMP, which the course assumes you already know
  • Advice on a specific audit or finding at your own site

This course is professional training. It does not replace your site’s procedures, and it is not regulatory or legal advice on a specific event.

Who it is for

  • QA auditors and supplier-quality staff at the contract giver, the marketing authorisation holder or the manufacturer
  • Anyone who audits contract manufacturers, contract laboratories, packers, storage and transport providers, or other suppliers of GMP activities
  • Anyone who commissions or accompanies a third-party auditor
For managers

Rolling supplier auditing essentials out to a team?

The Site Readiness Programme adds a team heatmap from the self-assessment, a live session on the weakest questions, and records named by employee ID. Quote within two working days.

  • Seats for the whole team, priced per learner from 5 learners
  • Anonymised team heatmap: which questions your people fail, by chapter
  • 90-minute live session built on the team's weakest questions
See the programme

Regulations referenced

  • EudraLex Volume 4, Chapter 7, 7.1 to 7.17
  • EudraLex Volume 4, Chapter 1, 1.4(xiv), 1.10 and 1.11; Chapter 4, 4.8 and 4.9; Chapter 5, 5.29 and 5.50
  • EudraLex Volume 4, Annex 11, 3.1, 9 and 12.4; Annex 16, 1.7 and 2.2
  • ICH Q10 Pharmaceutical Quality System, 4.1
  • Union format for GMP inspection reports and the EU procedure on the conduct of inspections, used as models

Continue the path

CMPPractitioner
Open for enrolment2 hours, self-paced

Complaints Essentials

Take a complaint in, record it so it can be investigated, judge whether it signals a quality defect, and close it with a conclusion that holds.

6 lessons · knowledge checks · scored final exam

€179excl. VATView course
RECPractitioner
Open for enrolment2 hours, self-paced

Product Recall Essentials

Decide when a defect needs a recall, notify the competent authority, execute the recall and reconcile what came back against what was distributed.

6 lessons · knowledge checks · scored final exam

€179excl. VATView course
VALPractitioner
In development2 to 3 hours, self-paced

Qualification and Validation Essentials

A short, complete course on Annex 15 as it works in practice: planning qualification and validation on risk, taking equipment from user requirements to performance qualification, validating the process and the cleaning, and keeping all of it in a validated state through change and time.

Curriculum in development · waitlist open

€179expected, excl. VATGet notified